Yaesu vx-246 software

Press the key the function of which you wish to change, then program the new setting according to the procedures described below. When re-programming is finished, turn the radio off by rotating the VOL control fully counter-clockwise into the click-stop. Activate the Programming mode.

If you wish to enable the Auto-Respond Paging feature, press the [ ] key. If you wish to disable the AutoRespond Paging feature, press the [ ] key. Ten different Paging Codes may be stored into Paging Memory registers, allowing you to page ten different stations or groups of stations. Enter the three digit code Paging Code from the keypad. You may change the operating frequency from among the eight available channel frequencies of the channel selected by the CH knob.

This function may be useful if you wish to change the order in which the frequencies are selected by the CH knob. Rotate the CH knob to select the channel on which you wish change the operating frequency. Press the [B] key, then enter the frequency number from the keypad. The stations can then move to a better location to re-establish communications.

If you wish to enable ARTS operation, press the [ ] key. Enter the three-digit DCS signaling number from the keypad. This procedure initializes the transceiver into its factory-default configuration the settings installed before you used if for the first time. In the event of erratic behavior, resetting the microprocessor may clear up any corrupt date, often restoring normal operation.

However, any customized settings will have to be re-programmed. Press and hold in the [A] and [D] keys while turning the transceiver on. Press the MONI button to initialize the transceiver. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Do not modify this transceiver for any reason.

Refer service of this apparatus to qualified technicians only. Plug the NC into the AC line outlet. Note: The FBA must not be used with rechargeable cells of any kind. Frequency Tone No. Frequency 01 Code No. Code DCS Off J-GK E C 0 2 5 U 7 6 1.

Rotate the CH knob to select a channel for operation. Press the [A] key. Operating Channel You may change the operating frequency from among the eight available channel frequencies of the channel selected by the CH knob. Use Directory Submission Commander's built in search to find and submit your site to unlimited targeted directories. The dual band FT handheld transceiver for amateur radio enthusiasts, first released in , is still very popular because of its wide-coverage receiver, 2-meter VHF band and centimeter UHF band.

You can do this in two ways, using a hardware method or a software method. PstRotator is a program for antenna rotators control. It works with a wide variety of rotators, supports a lot of loggers, DX cluster clients, satellites and moon trackers, and supports multiuser remote operation over the Internet.

This mode is BD All rights reserved. This is the place to come for a first look at the hottest new software. Shareware companies need your support.

Beta testing is a unique opportunity to try the latest programs and provide feedback directly to the program developers. The final version of many programs is often determined by suggestions from testers like you. Shareware Junction lets you choose from a variety of these products - all in one convenient location.

Use of this site subject to Terms and Privacy Policy. Interface Cable Tester v. CQLog v. DirectorySubmissionCommander Easily submit your site to unlimited directories with the power of search. FT Commander v. VX-7 Commander v. VX-6 Commander v. NGenLog v. Swisslog v.